Stretch Fabric Poseur Table

Overview

The folding poseur table with branded stretch fabric cover is perfect for use at almost any exhibition or event. It comes complete with a full colour, stretch fabric graphic that simply pulls over the table and hooks around the feet.

Ideal for exhibitions, buffets, marquees, parties, banquets, market stalls, fairs, awards nights, events and weddings.

The 260gsm 'stretch' fabric cover is designed to fit snugly over the folding table. It is then tensioned by securing elastic feet hems over the table feet. After the graphic has been applied, the result is a seamless look, with the inside of the unit completely hidden from all angles.

The inside of the unit is hollow, and as an example, can be used for storage of marketing material at an exhibition. Storage access is only via lifting/placing the table from above.

Easy for one person to assemble in 4-5 minutes.

The graphics are printed with a VUTEk FabriVU 340, resulting in a rich and vibrant finish which is excellent for exhibition and indoor displays.

The fabric cover is washable and easily changeable. Additional or replacement graphics can be ordered separately. Old graphics can be recycled with other textiles.

• Moulded plastic top
• Steel folding legs
• Includes a bespoke-printed graphic on Stretch Fabric
• Printed in-house on one of our VUTEk FabriVU 340 printers
• Cut in-house on one of our 3.2m-wide Zund cutters
• Finished in-house by our team of sewing machinists

There is no additional charge for more than one design or artwork for your order, no matter how many counters you are ordering.

Replacement Graphics

Replacement (new) Stretch Fabric Poseur Table graphics are available without the product hardware. Printed, finished and delivered direct to you or your client.

• Replacement Graphics for Stretch Fabric Poseur Table

What You Get

• 1 × Poseur table hardware
• 1 × Stretch fabric graphic

Measurements

Fitting the Graphic

Please bear in mind that the unit is intended to fit in one, specific direction, and will not fit suitably (and may tear) if applied incorrectly. For best results, follow these steps:

1. Unfold and lock the the hardware legs, and stand the unit on a clean floor/mat.
2. Slide the graphic side panels over the top of unit, leaving it loosely hanging down the sides.
3. Rotate and orient the graphic so that the rear panel is centrally aligned with the hand slots under the tabletop (the graphic seams should sit approximately on the leftmost of the left hand slot, and and the rightmost of the right hand slot).
4. Pull the graphic down, so that the top of the graphic is snug and taut over the table top section.
5. Continue to pull each corner of the graphic downwards, and hook each foot pocket over each of the foot of the unit. This may take some strength, but this ensures the graphic is taut and will pull out any creases.
6. Graphic application is now complete, though there can be some 'rippling' across the graphic if the graphic has become slightly twisted between the top section and the bottom feet. If this is the case, it is recommended to completely remove the graphic and start from the beginning.

Specification